New Member

Question

IPSec VPN Configuration with NAT on FortiGate-201F (v7.6.2)

Forum|Forum|1 year ago
June 4, 2025
2 replies
793 views

Dear Concern,

I need to configure an IPSec VPN on my FortiGate firewall, where user traffic should be NATed to a specific set of dynamic IP addresses before reaching the remote side. This is necessary because the remote side will only allow traffic from a few specific IP addresses. Kindly assist me in configuring this setup.

My Firewall Details:

Model: FortiGate-201F
Firmware Version: v7.6.2 build3462 (Feature)

FortiGate

New Member

Here is the official documentation for IPSEC VPN with overlap subnets (meaning using NAT).

Site-to-site VPN with overlapping subnets | FortiGate / FortiOS 7.4.3 | Fortinet Document Library

The only difference from you case is that you only need to make the changes for NAT on your side, just ignore the remote side.

Mirza_Asad2723Author

New Member

@adrianiovita

Thank you for sharing the guide — I will follow it accordingly.