Skip to main content
Anda
Anda
New Member
September 7, 2017
Question

IPSEC Tunnel Change remote gateway

  • September 7, 2017
  • 1 reply
  • 4227 views

Hi,

i have a VPN Ipsec between a 30E and 60D already working. So far, so good.

Now, we need to change Wan line, from 30E. So, i have to change remote ip in 60D. And i have also changed preshared key, as i do not remember it. Obviously, i have changed the preshared key in 30E and 60D.

But, surprise, for me, sure, the tunnel goes up, but no traffic flows.

Back to old gateway, all is ok!

So, i need help... what should i do in this case?

 

Many Thanks,

            Antonio

 

    1 reply

    ede_pfau
    SuperUser
    ede_pfau
    SuperUser
    September 7, 2017

    hi,

    it might well be that there is an old session still active in the session table. I think if you disable the corresponding policy and re-enable it it's sessions will be terminated (quicker than some diag command...).

    Of course, you could always just reboot the 60D as well.

    Terms & ConditionsAccessibility statement