Skip to main content
Michaelwright1900
Michaelwright1900
New Member
September 15, 2020
Question

IPsec Hub and Spoke Topology

  • September 15, 2020
  • 1 reply
  • 2148 views

Hiya

I have been tasked with a project at work to create upto 3000 VPNs to remote devices. I have chosen to go with the HUB and Spoke topology because the remote devices will be using SIM cards and will be a mixture of 3rd party routers. We cannot use DDNS sa they are mobile devices and will have dynamic public IPs.

 

The HUB and Spoke topology should do the job. But there is a requirement by the department we are doing the work for; Due to the amount of IP subnet pools that would be needed for the remote devices(mixture of different customers). it has been requested we do not publish subnets from the remote devices, but we use the VTI (route based VPNs)and DST-NAT to the devices behind the remote routers(spokes). To do this we would need to know the VTI IP addresses on every VPN. 

 

Is this possible or am I wasting my time?

 

Mike

    1 reply

    emnoc
    emnoc
    New Member
    September 16, 2020

    Why?

     

    So if you are going to do dst-nat than you need to set and manage 3000x site DNAT which by that a alone would be a challenge.

     

    Does the 3000x device have services that the hub would ever connect to?

     

     

    Ken Felix

    Terms & ConditionsAccessibility statement