IP Address of virtual-switch (hardware-switch) not in routing table

Hi all,

I'm very new on fortigate firewall.

I'm configuring a FG100D, it's running in "interface mode" and I need to bridge 2 interfaces, so I created a virtual-switch: I tried both GUI and CLI, then I set an IP Address on the interface "Virtual-Switch".

Testing with a ping, I can reach 2 devices connected to virtual-switch, but in "Routing->Monitor" there is not entry with the net assigned to VS, I also create some static routes and, of course, those routes are not in routing table.

Software-switch works well.

Do you have any suggestion?

This my virtual-switch config:

config system virtual-switch edit VS01 set physiscal-switch sw0 config port edit port 9 end edit port 10