Skip to main content
KWigle
KWigle
New Member
November 25, 2015
Question

Internal UP but not connected

  • November 25, 2015
  • 1 reply
  • 3894 views

Just a funny.... on a factory reset FortiWifi 80CM, in System->Network->Interface..... the Link Status shows as UP for Internal but there are not any cables connected.

 

There are no lights lit for Internal on the front.

 

Is this a known bug?

1 reply

Toshi_Esumi
SuperUser
Toshi_Esumi
SuperUser
November 25, 2015

Is your 80CM in switch-mode or interface-mode for internal-switch-mode? "internal" is a logical interface and in my case with FG60D v5.2.3 is in "internal-mode" and internal is hard-switch/virtual switch that has 7 members of physical interfaces (internal1...internal7). And the status of "internal" is always up unless I "set status down" which all member physical interfaces are "down" if nothing is connected.

Toshi_Esumi
SuperUser
Toshi_Esumi
SuperUser
November 25, 2015

Sorry for a typo. I meant " ..v5.2.3 is in "interface-mode"...

Terms & ConditionsAccessibility statement