Skip to main content
huzefa
huzefa
New Member
February 26, 2019
Question

Install only Remote Access component of FortiClient 6.0.5

  • February 26, 2019
  • 2 replies
  • 8058 views

Hello,

Our organization needs to install FortiClient with only Remote Access component enabled.

Is there a way to install FortiClient with Vulnerability scan and Compliance and telemetry disabled?

 

Thank You.

    2 replies

    Markus
    Markus
    New Member
    February 26, 2019

    Hi and welcome to the Forums. Yes, this is possible. You need Fortclient EMS (or the Toolkit from the Dev Netwotk) to customize Forticlient installer package. http://help.fortinet.com/fclient/ems/1-2-5/FCT-EMS-Admin-Guide/1200_Administration/0630_Upload%20FCT%20installers.htm Best regards

    SteveG
    SteveG
    New Member
    February 26, 2019

    I'm pretty sure when you run the publically available installer on both MAcOS and Windows you can customise the install and choose Remote Access only.

    Toshi_Esumi
    SuperUser
    Toshi_Esumi
    SuperUser
    February 26, 2019

    If it's not a mass instalation, you can donwload (backup) the config and search for below XML statements and change those '1's to '0's to disable. Then restore the config.

     

        <endpoint_control>         <enabled>1</enabled>

     

       <vulnerability_scan>         <enabled>1</enabled>

    huzefa
    huzefaAuthor
    New Member
    February 26, 2019

    Hi,

    How / From where do I download the config file?

    It does not exist in the installer package.

    Thanx.

    Terms & ConditionsAccessibility statement