how to reset hit counts for SD-WAN rules?

Hi @ICT_Putte , 

Here are the steps: 

1. Run the command 'diag firewall proute list '

2. Look for the relevant sdwan rule:

id=2130706435(0x7f000003) vwl_service=3(test)
source(1): 0.0.0.0-255.255.255.255
destination(1): 0.0.0.0-255.255.255.255
hit_count=179316 last_used=2022-10-20 13:04:57

3. Run the following command: 

2130706435 is id for this sdwan rule

diagnose firewall proute clear 2130706435

4. Result: 

id=2130706435(0x7f000003) vwl_service=3(test)
source(1): 0.0.0.0-255.255.255.255
destination(1): 0.0.0.0-255.255.255.255
hit_count=0 last_used=2022-10-20 13:05:58

Hope this helps. 

Thank you. 

Shahan

Hi @aionescu and @sagha 

Thanks for the info. With it I managed to clear the hit count.

I noticed some strange behaviour thou (maybe a bug in the firmware version I'm using?):

When I used the command with a specific id of a sdwan rule it didn't work.

'diag firewall proute clear <id nummer> ' didn't gave an error but it also didn't clean the hit count.

If I gave the same command without the id nummer it cleared all the hitcounts of all the rules (as expected).

The firmware I'm using v7.2.2 build 1255.

With kind regards.