Skip to main content
papapuff
papapuff
New Member
October 24, 2019
Solved

How to make one interface connect to 2 interfaces

  • October 24, 2019
  • 1 reply
  • 7024 views

hi there,

we use FG-60D. all ports already configured as interface.

we want to make 1 port can connect to multiple other ports.

incoming port: Port_A

10.10.10.X, gateway: 10.10.10.1

other ports:

Port_B: 192.168.10.X, gateway 192.168.10.1

and WAN

 

I want:

on Port_A, destination to 192.168.10.10 and 192.168.10.11, will redirect to Port_B, and connect to 192.168.10.10 or 192.168.10.11. each destination has different service.

for other destination, will connect to Internet over WAN

 

I have configure:

- IP Policy, Port_A to Port_B; with destination 192.168.10.10 and 192.168.10.11 (each destination has its policy)

- IP Policy, Port_B to Port_A, with destination to all IP range on port_A and all services.

- IP Policy, Port_A to WAN, source IP is Ip Range on Port_A, destination to all

- Policy Route:

Any port, Port_A with outgoing 192.168.10.10, 192.168.10.11 forward to port_B 

any port, Port_A to with outgoing all forward to WAN

 

Am I miss something? Port_A can't connect to internet, nor to port_B

 

please help. thank you

    Best answer by Toshi_Esumi

    You're probably missing the basic routing concept. Based on what you explained routes&policies should take care of traffic you described. If the default route is going toward WAN, that's all you need for routing. 10.10.10.0/24 and 192.168.10.0/24 are both directly connected routes. You seem to have all policies necessary. No need for PBRs.

    1 reply

    papapuff
    papapuffAuthor
    New Member
    October 24, 2019

    update progress,

    now the problem is, Port_A can't connect to internet.

    the rest already done.

     

    please help

    Toshi_Esumi
    SuperUser
    Toshi_EsumiAnswer
    SuperUser
    October 24, 2019

    You're probably missing the basic routing concept. Based on what you explained routes&policies should take care of traffic you described. If the default route is going toward WAN, that's all you need for routing. 10.10.10.0/24 and 192.168.10.0/24 are both directly connected routes. You seem to have all policies necessary. No need for PBRs.

    papapuff
    papapuffAuthor
    New Member
    October 25, 2019

    hi Toshi,

    thanks for remind me.

     

    still I can't figure out why 10.10.10.0/24 (port_A) can't connect to internet.

     

    what other configuration I need?

     

    thanks in advance

    Terms & ConditionsCookie settingsAccessibility statement