Skip to main content
jerry_ku
jerry_ku
New Member
December 26, 2018
Question

How to factory reset a FAP222B without the POE adapter?

  • December 26, 2018
  • 2 replies
  • 6470 views

Is it possible to factory reset a FAP222B without the POE adapter?

 

I can't determine the IP address of the FAP222b I have. When I sniff it on Wireshark, it never sends any ARP broadcasts

 

 

    2 replies

    Toshi_Esumi
    SuperUser
    Toshi_Esumi
    SuperUser
    December 27, 2018

    There is a hole of a reset switch at almost top on the front panel. Use a paper clip or something similar to press and hold for 5 sec until LED indications change.

    Philgre
    Philgre
    New Member
    January 10, 2019

    Yes, just insert a needle into the hole to make a fatoryreset.

    Yurisk
    SuperUser
    Yurisk
    SuperUser
    January 11, 2019

    As already said, will just add for reference picture:

    Dave_Hall
    Dave_Hall
    New Member
    January 11, 2019

    The FAP 222B looks to be an outdoor unit and doesn't look to have a reset pinhole unless it is hidden/enclosed in the case itself. The quick start guide only indicates the reset pinhole on the POE adapter itself.  (The 222A looks to be an indoor unit though?)

     

    Unless you have manually configured this 222B with a static IP, it should make attempts to obtain a routable IP from a DHCP server (via DHCP option 138) , failing that it should default to using 192.168.1.2.  If this AP is connected to the network with a fgt unit (running DHCP service) you should see the MAC/IP address show up in the DHCP monitor.  If Device Detection is enabled on the network (interface), you should be able to see it under "User & Devices -> Device Inventory->Fortinet Device".

     

    Assuming the 222B is failing to obtain an IP (lease), it may be defaulting to 192.168.1.2, so either configure a port on the fgt for that subnet and stick the AP on that port or bind a secondary IP in that subnet range to the interface.

     

    Make sure you have CAPWAP enabled on the interface that the AP will be communicate through.

     

     

    Terms & ConditionsAccessibility statement