Skip to main content
WQTpicap
New Member
Apr 2, 2026 1:22 PM UTC
Solved

How to create site-to-site VPN via Fortimanager without using VPN community

Hi, we want to create a site-to-site VPN via Fortimanager, but don't want to enable VPN community. Is the following procedure correct? our Fortimanager os version is 7.4.x. 

1. login to Fortimanager Device Group

2. choose the firewall 

3. click VPN  and choose interface mode

4. create phase 1 

5. create phase 2

6. install the config via installation wizard

Can anyone please help to advise? Thanks in advance!

 

 

farhanahmed
Staff
Apr 2, 2026 9:42 PM UTC

After the tunnel interface is created you can map it to a normalized interface Policy & Objects > Normalized Interface (create new - better to match name of tunnel) and use it policy packages.

https://docs.fortinet.com/document/fortimanager/7.6.6/administration-guide/80387/configuring-normalized-interface-per-device-mapping-rules 

www.farhan.ch

7 replies

Anthony_E
Staff
Staff
Apr 2, 2026 2:12 PM UTC

Hi WQ,

 

I found a documentation:

https://docs.fortinet.com/document/fortimanager/7.6.3/administration-guide/386468/configure-site-to-site-vpn-using-fortiai-example

 

Could you please have a look into it?

 

Regards,

Best Regards
WQTpicap
WQTpicapAuthor
New Member
Apr 2, 2026 2:24 PM UTC

Hi @Anthony_E , thanks for your advice. However, we don't use FortiAI. we just use normal Fortimanager. is there any doc we can refer to? Thanks in advance!

Anthony_E
Staff
Staff
Apr 2, 2026 2:35 PM UTC
Best Regards
farhanahmed
Staff
Staff
Apr 2, 2026 4:04 PM UTC

Hi,

 

If you do not want to use VPN-Manager then the procedure you mentioned is correct - that is use the FortiManager Device Manager to configure the VPN. After installing the VPN config to the FGT make sure add per-device mapping for the tunnel interfaces in FMG ADOM so you can use the tunnel interfaces in policy packages.


www.farhan.ch
WQTpicap
WQTpicapAuthor
New Member
Apr 2, 2026 8:33 PM UTC

Hi @farhanahmed , thanks a lot for your advice! Regarding adding per-device mapping for tunnel interface, can you please provide more detailed steps? After VPN  installation, it will automatically create a tunnel interface, right? so I need to carefully find the tunnel interface which was just created and use it in firewall policy config, right? Please help to confirm and advise, thanks. 

farhanahmed
Staff
Staff
Apr 2, 2026 9:42 PM UTC

After the tunnel interface is created you can map it to a normalized interface Policy & Objects > Normalized Interface (create new - better to match name of tunnel) and use it policy packages.

https://docs.fortinet.com/document/fortimanager/7.6.6/administration-guide/80387/configuring-normalized-interface-per-device-mapping-rules 

www.farhan.ch
Thought Leadership. Security Summit. Thursday, November 12th, PGA National Resort, Palm Beach Gardens, FL.
Security Operations Summit: Modernize SecOps. Operate AI-Native.AMER: November 4 | 9:00 AM PST. India and SAARC: November 5 | 10:00 AM IST. EMEA: November 5 | 10:30 AM CET. APAC: November 5 | 11:00 AM SGT