Skip to main content
FrancoisSogeclair
FrancoisSogeclair
New Member
October 19, 2015
Question

How to create IPSEC between Fortigate and Netasq

  • October 19, 2015
  • 1 reply
  • 4096 views

Hi,

 

I try to create IPSEC between FG300C (5.2) and Netasq U70.

In fact i have a lot of IPSEC between Fortigate, but with another router never. If you know where can i find information or process to do this ?

 

Best regards,

 

François

    1 reply

    ede_pfau
    SuperUser
    ede_pfau
    SuperUser
    October 19, 2015

    Hi,

     

    and welcome to the forums.

    I'm sorry I don't have any example for this but you should be able to find the available conditions with Netasq. The Fortigate is highly flexible regarding IKE modes, IKE and IPsec parameters, ciphers, authentication etc.

    Resources for this on the FGT side would be the Handbook, the Cookbook for illustration and the Knowledgebase.

    FrancoisSogeclair
    FrancoisSogeclairAuthor
    New Member
    October 20, 2015

    Hi,

    Thank you but if i post here it's because i didn't find solution. Yesterday morning i tried to mount ipsec tunel with my Fortigate and a Netasq of another company but we canno't finished.

    We found another solution. I 'll go this afternooon install a small fortigate in parallel of Netasq just to mount tunel. I know i don't resolve trouble but i don't stop production.

     

    François

    Terms & ConditionsAccessibility statement