Getting error of need frag (MTU 1500)

Dump on the traffic between the 2 hosts, you have the DF-bit set and the packet is to large. So the icmp.type 3 code 4 message is being sent back to you. You have a few options and one is simple, use the fwpolicy to set the mss value on traffic between the src/dst address i.e ( set tcp-mss-sender | receiver ) or clear the DF-bit so the packet can be fragment.

how can i clear DF-Bit from my end. and how can i check the current ' tcp-mss' value for any policy

1: the set tcp-mss-sender/receiver is done per fwpolicy and not enabled by default it' s also done via the cmd line 2: You can clear the df-bit at the host and iirc I think within a fwpolicies, let jump into a firewall and confirm that. You also can easily do the same with a service-policy map within cisco IOS. So if you any firewalls or switches that are L3, you can craft policy and apply it ahead of the firewall to clear the df-bit. B4 you waste all of that time, you need to get the mss value ( tcpdump ' tcp[13]==02' ), that' s being sent and then adjust it with firewall policy after you know what your sending and receiving i.e config firewall policy edit 445 set srcintf " LAN01" set dstintf " EXT02" set srcaddr " MWEBAPPNET01" set dstaddr " any" service " HTTP,HTTPS" set tcp-mss-sender 1436 set tcp-mss-receiver 1436 set comments " set mss for all webtraffic , due to our DDoS gre tunnel limits" next end