Skip to main content
Jannick
New Member
Jan 29, 2025 7:08 AM UTC
Question

Get a notification when a new device is detected on a FortiSwitch port

Hi!

 

I'm looking to implement an automation in my FortiGate E100 in case on a specific port on my FortiSwitch 224E-POE a new MAC Address is detected.

 

The only problem I'm facing is, how to detect this properly?

 

I did some digging online and found out about sticky MAC addresses. I've enabled this for one specific port where always 1 specific device is connected to. I've setup the sticky MAC to persistently remember 1 address.

 

I managed to get a FortiSwitch notification about the detection of a new device (other than known in the remembered sticky MAC address) in the FortiSwitch Systems logs, but I cannot manage to get a notificaiton about it.

 

In the FortSwitch System Logs I did notice a new enterance, that looks like this:

Interface MAC learning limit exceeded, MAC 84:XX:59:XX:e9:XX on port11 (Packet VID: 1). - FortiSwitch system

 

So to just try out I made a Trigger in the Security Fabric Automations for notifications from the FortiSwitch system, like this:

 

FortiGate-100E (SYSTEM) # show
config system automation-trigger
edit "SYSTEM"
set event-type event-log
set logid 32699
next
end

and attached the trigger to a Stitch, but no matter what, it doesn't trigger.

(logid 32699 = FortiSwitch system)

 

My questions:

What is the best method for detecting a new device on a FortiSwitch port that normally always has the same device connected and triggering a Security Fabric Automation?

 

Why does my current trigger (when attached to a Stitch) no trigger an automation while being so broad?

 

Versions:
FortiGate: v.7.2.10

FortiSwitch: S224EP-v7.4.1-build0787

 

Thank you!

1 reply

Jannick
JannickAuthor
New Member
Jan 29, 2025 8:49 AM UTC

I now managed to get a notification from the FortiSwitch system.

What I forgot to setup a 'Field Filter' on the message.

 

My trigger now looks like this

config system automation-trigger
edit "SYSTEM"
set event-type event-log
set logid 32699
config fields
edit 1
set name "msg"
set value "Interface MAC learning limit exceeded*"
next
end
next
end


The only question that still stands, is this the best way? I have the feeling there are better ways to detect a new device connecting to a port that always has the same device (with the same MAC address) connected to it.

Translate
Risk and Resilience in the Age of AI. An OT Thought Leadership Summit for Houston's Critical Infrastructure Leaders. Date: Thursday, December 3, 2026. Time: 8:30 am - 1:30 pm (CT). Location: The Westin Houston, Memorial City | 945 Gessner Road, Houston, TX 77024