Skip to main content
Kjoebie
Kjoebie
New Member
August 30, 2018
Question

FortiSwitch 108D-POE failure

  • August 30, 2018
  • 1 reply
  • 7048 views

Hello,

 

I rebooted my 108D-POE and now it isn't working anymore. Only port 1 shows a green light when I put a cable in it. All the other ports show a fade amber light (see picture). It does not respond when a cable is inserted.

The reset button does not work. After 10-15 seconds nothing happens. Port 1 replies to ip 192.168.1.99 but I cannot start the GUI.

 

Any ideas?

 

Regards,

Albert

 

    1 reply

    SecurityPlus
    SecurityPlus
    Explorer III
    September 1, 2018
    Have you contacted Fortinet support yet concerning this issue?
    ede_pfau
    SuperUser
    ede_pfau
    SuperUser
    September 1, 2018

    If it's got an external power supply you could test a replacement PSU. I suspect the PSU has failed. Open a support case anyway.

    Kjoebie
    KjoebieAuthor
    New Member
    September 11, 2018

    HI All,

     

    Thanks for the replies. I used an RMA to replace the switch.

     

    Thanks.

    Albert

    Terms & ConditionsAccessibility statement