Installed it on 2 separate 50E with SD-WAN. Both crashed after a while without console output. Not pingable and nothing in the crash-log. LEDs still blinking but is not reacting to console input.
First box had Interfaces and VPN Tunnels in SD-Wan and had some Performance SLA and it dies after 5-10 Minutes. Deleting Performance SLA could raise the time to die to about 1-3 hours.
Second box which has only 2 WAN as SD-WAN interfaces and only ping Performance SLAs dies after about 24 hours.
Hello all, I’ve upgraded a 60E to 6.0.1. Since the update the FortiView “Bytes (Sent/ Received)” counters seem to have gone wrong. For example I have one Rasberry Pi which is indicating over 817GB sent during a 24 hour period (normally it would send perhaps 5 GB and it’s config and status haven’t changed). Other devices seem to be reporting similarly high data volumes, while others look relatively normal. The Raspberry Pi is sending mainly UDP packets so it’s possible it’s just UDP traffic volumes not being recorded correctly. The high data volumes are also being reported through to FortiCloud and FortiAnalyzer. However, the figures being reported can’t be correct. The VDSL service I use has 1000 GB per month cap. And the ISP is reporting “normal” useage of around 10 GB per day. Nothing like the FortiGate reported values. Anyone else seeing this? Anyone got any ideas of what I should check? Thanks in advance, Andy.
