Hi All,
I'm familiar with Hardware Switch mode on the FG200D series, however in 5.2 firmware have seen VLAN Switch mode.
What is the difference, as you can create VLAN's on a hardware switch interface too?
From the GUI there doesnt appear to be a difference, unless you can tag and untag VLANs on members in the VLAN Switch mode from the CLI ?
Hello,
There is 3 type of switch : - software switch : traffic is processed by CPU, but this switch is more "flexible" : you can add to this switch a VLAN interface, hardware switch or physical interface. - hardware switch : traffic is processed by asic, but you can only add physical interface - VLAN switch : it's the same as a hardware switch, but only available on 1xxD or 2xxD series. You define a VLAN for the switch, and you can define a trunk port. This trunk port can be connected to a switch to propagate the VLAN define in your VLAN switch (only the vlan define in your VLAN switch, the VLAN interface is not propagate) to your access switch, or connect to your slave firewall to be able to use the port on your slave firewall (http://cookbook.fortinet....dundant-architecture/)
Lucas
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
