Skip to main content
an0nymous
an0nymous
New Member
June 29, 2020
Question

Fortinet 60e doesn't boot?

  • June 29, 2020
  • 1 reply
  • 3150 views

Hi,

 

This is JUST out of support, and I attempted to factory reset it, as I intended to play with it. When I did so, it no longer booted up.  Then, when I tried a different clover lead, it powered up for about...1 second, and then it stopped again. What can I do in this situation? I can't also connect to it via serial too given it simply won't power up. I have tried nonetheless however.

    1 reply

    lunhas2k4
    lunhas2k4
    Explorer II
    June 29, 2020

    Hi,

     

    It appears that it might be bricked, judging from what you've said.

    Connecting the serial cable a power-cycling it should give you some kind of output on you terminal.

    Do you confirm that there is absolutely nothing on the screen?

    If so, from the little experience I've had RMA is the solution. But you say that support is just expired as well.

    Without any output you will not be able to do much.

    Let us know how it goes.

     

    an0nymous
    an0nymousAuthor
    New Member
    June 29, 2020
    Lunhas2k4 wrote:
    Hi,   It appears that it might be bricked, judging from what you've said. Connecting the serial cable a power-cycling it should give you some kind of output on you terminal. Do you confirm that there is absolutely nothing on the screen? If so, from the little experience I've had RMA is the solution. But you say that support is just expired as well. Without any output you will not be able to do much. Let us know how it goes.  
    That's what I did and there was no output to the screen, so unsure of what else I can do? Thanks
    Terms & ConditionsAccessibility statement