Fortinac-f 7.6 and Accesspoint detection

Hi!
I want to use 802.1x MAB to recongnize FortiAPs connected to FortGate controlled switch.
So I enabled this setting: "Enable Network Access Policy for Wireless Access Points"

Now I found, that Accesspoints, that were found before this setting, are not in Hosts view(this is not problem) and their ports goes to WAP Uplink mode in NAC inventory.

After I enabled "Enable Network Access Policy for Wireless Access Points",(and created OUI based profiling rule) this one still keeps WAP uplink "state" and it's OK.

BUT:

When I now add new AP to another port, Port Connection state is :
"Registered Host"

And MAC address of AP goes to hosts list.

Can I force new APs to go same state, as the first one?

I use radius attribute group to return all needed VLAN, so that part works.

BR, A