Skip to main content
ss198939
ss198939
New Member
February 28, 2018
Question

Fortimanager- Push to device- Partial Install enable- not working

  • February 28, 2018
  • 2 replies
  • 18515 views

Hi Dear, i have enabled partial install via CLI. as per below link. but now also i am not able to push any newly created object. like i have created new LDAP object and i want that should go to the firewall which i have added by per device mapping. i am getting error there is not install device. http://help.fortinet.com/...00_Push%20an%20object.

    2 replies

    chall_FTNT
    Staff
    chall_FTNT
    Staff
    February 28, 2018

    Any object you wish to install with partial install must be referenced in the policy package associated with that device.  If that is the case and you still get an error, can you provide the exact syntax of your error?

    chall_FTNT
    Staff
    chall_FTNT
    Staff
    February 28, 2018

    For more information, see Push to Device

     

    ss198939
    ss198939Author
    New Member
    February 28, 2018

    @ chall_FTNT thanks for quick answer. it was never expected that much quick response.

    what i understood is :- if i am creating any object then i need to call that object in policy. otherwise it will show the same error.

     

    so what is the use of partial install. because earlier also i have to call the newly created object in policy then it got reflected in firewall.

    MERANA
    MERANA
    New Member
    March 4, 2018

    make sure its not created as dynamic object if it is then you have to go into the edit of the object and map to device. after doing so if you push it will show you in the push config of FG

    Terms & ConditionsAccessibility statement