FortiGate wwan passthrough

Hello,

Thank you for using the Community Forum. I will seek to get you an answer or help. We will reply to this thread with an update as soon as possible.

Thanks,

Hello,

We are still looking for someone to help you.

We will come back to you ASAP.

Thanks,

Hello cgordondgrsys,

I found this solution. Can you tell me if it helps, please?

In the scenario you described, FortiExtender is typically used to extend the WAN interface in IP pass-through mode, allowing the FortiGate to manage the connection and apply security policies. However, if you are considering using a dual 3G/4G setup with a FortiGate WWAN interface to terminate the connection to a private cellular APN and pass the assigned IP to a device behind it, here are the steps you might consider:

1. Configure FortiGate WWAN Interface:
   - Set up the WWAN interface on the FortiGate to connect to the private cellular APN.
   - Ensure that the FortiGate is configured to handle the IP assignment from the cellular network.
   
   
2. Enable IP Pass-Through: Configure the FortiGate to operate in IP pass-through mode, if supported, to pass the assigned IP address to the device behind it.
   
   
3. Device Configuration: Ensure the device behind the FortiGate is configured to receive the IP address passed through from the FortiGate.
   
   
4. Security Policies: Apply necessary security policies on the FortiGate to manage and secure the traffic passing through the WWAN interface.
   
   
5. Testing and Validation: Test the setup to ensure that the IP address is correctly passed through and that the device behind the FortiGate can communicate as expected.

Please note that the specific capabilities and configurations may vary based on the FortiGate model and firmware version. If the FortiGate does not support IP pass-through in this manner, you may need to consider alternative configurations or consult Fortinet support for further assistance.