Skip to main content
YtseJam
YtseJam
New Member
December 11, 2015
Question

Fortigate to StormShield (NETASQ) VPN (ipsec s2s )Setup

  • December 11, 2015
  • 1 reply
  • 10711 views

Hi All,

 

I just can't establish a VPN (ipsec s2s) tunnel on my fortigate to our remote sites that has a StormShield (NETASQ) firewall. Does anyone tried it already using those two medium mention above to establish a vpn tunnel? Please advise. Refer to attached files for my config. Thank you.

 

Regards,

JAM

    1 reply

    gschmitt
    gschmitt
    New Member
    December 15, 2015

    In the CLI (with putty for example)

    diag debug reset

    diag debug enable

    diag debug application ike -1

    Capture the output

    YtseJam
    YtseJamAuthor
    New Member
    December 16, 2015

    where do I need to run that commands, in fortigate's CLI? I tried it, but no results. 

    Terms & ConditionsAccessibility statement