Fortigate FG60D two WAN VIPs on WAN2

Forum|Forum|8 years ago
September 25, 2018
3 replies
3295 views

Hello everybody. There is such a problem, I need to do VIPs from WAN2 to one of the PC in guest network.

VIPs for mail server on WAN1 work`s fine, but when I make another VIP on WAN2 it`s not work.

( Lan) interface Port 1 : 172.16.1.1/24 ( Guest_Lan )Interface: Port2 : 10.10.10.1/24 WAN1 :100.100.100.1/29 WAN2 :100.200.200.1/29 Static routes: WAN1 :100.100.100.1/29 distance 10 WAN2 :100.200.200.1/29 distance 20 Routing policy (guest lan) routed from Port2: 10.10.10.1/24 to WAN2 : 100.200.200.1/29 Ipv4 Policy : Incoming interface : WAN2 Destination Interface :Guest-Lan

Sourse Subnet :All Destination Subnet :VIPs Set Service :All Set action :Allow Nat :Disabled

What I miss?

Sudarsan_Babu

New Member

Hi,

Kindly to do below steps:

Change WAN2 distance as 10 .

So WAN2 will be active routing table. Now traffic will be flow.

Toshi_Esumi

SuperUser

If you want use wan1 for the rest, you can set priority like 10 (lower priority) on wan2 side. The default value is 0 (on wan1) so it's preferred for outgoing traffic (sessions).