Skip to main content
kulas
kulas
New Member
January 16, 2020
Question

FortiGate DHCP

  • January 16, 2020
  • 2 replies
  • 3438 views

Hi Everyone!

 

Good day!

I was trying to work with this scenario and anyone could help me if this is possible? See attached test.jpg. I have a FortiGate, a core switch, distribution switch and client pc. The goal is that FortiGate must act as the DHCP server of all the VLANS (10,20,30). I've already tried to create vlans on the FortiGate (same vlans from the core switch) and enabled dhcp. I already tried to allow all vlans from the core switch (trunk) going to the firewall. The result, the test client in vlan 30 can obtain IP from the firewall, but cannot access internet even firewall policy was already configured on the firewall (virtual interface (vlan30) to WAN)).

 

Best Regards,

Kulas

    2 replies

    Fullmoon
    Fullmoon
    New Member
    January 16, 2020

    fresh from implem today, similar design to the one i configured earlier. You can craft fortigate all the vlans you wish to define to the parent interface (e.g port 1 or dmz). now configure your L2 switch to have vlan id same as your fortigate and assign interfaces to its corresponding vlan id's. dont fortigate to choose 1 port from your switch and configure it as trunk port so that it will carry different vlan id's.

     

    For testing purposes enable dhcp server on each FGT sub interfaces so that it will lessen the time configuring ip address for each vlans to your test machine. Don't forget as well to define firewall policy to grant vlan sub-interfaces going to your wan(x) interface for internet access.

     

     

    ShawnZA
    ShawnZA
    New Member
    January 16, 2020

    No need for vlan's on the fortigate then.

     

    Create the other DHCP pools on the Fortigate in the cli if you haven't already, but seeing that the client is getting a IP you probably created them all already.

     

    And then make sure your policies is using your internal interface as that is where the traffic would be coming from.

    vlan 1 interface (or whatever port the core is plugged into) of your FW is your internal interface

     

    Delete any VLAN interfaces you might have created on the Fortigate, you mentioned  (virtual interface (vlan30), remove them if you haven't already.

    Add the IP helper address of 192.168.1.254 on all the 3 SVI's on your core

     

    Terms & ConditionsAccessibility statement