Fortigate can't ping via cli over VPN

emnoc wrote:

The only way I can is if I specify in 'ping-options' to use the internal address of 'x' fortigate device, if done this way pinging works.

 

 

That's correct and the correct way.  So pings are working if you source it correctly.

 

Are you sourcing the log via that same interface? Is that even a option in your unit(s)?

 

 

I see, strange it works on the lower end units with internal switch interfaces. Is there any valid reason it acts this way?

Not sure exactly what you are asking, but whatever is my internal interface is my management interface. So lets say my fortimanager is on: 10.10.100.5, but my Fortigate is at: 10.10.101.1. Fortimanager sees and connects to the unit at: 10.10.101.1. That works fine sending configs from Fortimanager, or retrieving information. However logs are not being transmitted from the unit up to the manager even though there is a valid tunnel. If I am in the GUI and try to 'test connectivity' it fails each time, and I can only assume it's because the unit is generating traffic and it doesn't go out the right interface. Is there anyway I can force traffic like this to go out 'x' interface?

emnoc wrote:

However logs are not being transmitted from the unit up to the manager even though there is a valid tunnel.

 

Have you looked at the "set source-ip x.x.x.x" option in the config syslogd  settings? You can specify the source and in your case it would be a interface in the src-subnet range for the vpn.

 

I be you in your case the logs are being sent using the egress interface address and not  a address routed thru the vpn.

 

Another option is to set  layer3 address on the vpn-interface ( assuming you are using routed-based-vpn ) and use that as a source. You will need to ensure firewall policies allow the traffic.

 

Last option is to use the  native ipsec encryption within FortiOS. This is depending on  FortiOs versiob but if your in a  FortiOS 5.x it should be supported.

 

 

Thank you, setting the syslog config worked! Kind of annoying that I have to dive down into the CLI commands for this, especially for all my units but it's easy enough to solve. I am confused as to why I set it for 'syslogd' and not for 'Fortianalyzer'.

However, would it be more of a recommended practice to enable FMG access on my 'wan' link and then secure the connection using FMG? Meaning if I were in device manager I'd right click on 'x' unit and there's 'secure connection' to create an IPSEC tunnel from FMG to the unit. Obviously I've not enabled that because it's currently all going internal so it's unnecessary.

One last question about the 'layer 3' option you mentioned above. I'm not entirely sure how I would do that (networking is not my strongest suit) and would it also take care of my CLI ping "issue"?