FortiGate can' t be upgraded

hi, v4.3.13 has been withdrawn and replaced by 4.3.14. But current version is one up, 4.3.15. Can you please post what you did step by step and at which point you get the error message? General steps for upgrading: 1. Back up your configuration ! 2. Reboot FGT before upgrading (to clear possible memory leaks) 3. Upgrade via WebGUI 4. Monitor success via console: " diag deb config-error-log read"

Please note if your box does not have a current FortiCare subscription and you chose to Upgrade from Fortinet (not local disk) you will be prompted " access denied" as well. Please also check: Are you " super_admin" ?

Also getting the same " access denied" error after putting 4.0 MR3 Patch 12 on 2 x 200B and 3 x 80CMs. (These fgt devices all have valid subscriptions.) When the problem started with a 200B we have in the field, we contacted Fortinet support -- they basically told us to format the boot device and reinstall the firmware. (This didn' t help us one bit as the fgt in question was in a remote area of no-man' s land" with no actual techie on site.) After the above happen, I did some further testing with 4.0 MR3 Patch 12 on units in the office (200B and 80CM models) -- even with a refresh " exec factoryreset" on them -- I couldn' t perform a GUI firmware upgrade once this firmware was installed.

When I manage the firmware via " Details" any firmware upload fails with " Access Denied" statement. However, when I use " Update" (no boot) the firmware does upload to the firewall. This on a 1240B with v4MR3p12.