Skip to main content
federico123
federico123
New Member
July 8, 2015
Question

Fortigate 800C wan1 link down

  • July 8, 2015
  • 1 reply
  • 3218 views

Hi forum,

I have a new setup with two 800c in HA in NAT operation mode, when plug a cable in wan1 link does not go up.

The same happens with port1, wan2 and port2, while all the other ports work properly.

I think it is related to wan1/2-port1/2 being in bypass group, but I can't find any setting related to this configuration that helps me.

I also found that under both USB port there is a dip-switch, is this related with the bypass feature?

Can wan1/port1 and wan2/portw be configured independently (after getting them working of course :) ?

 

Best regards,

Federico Chiacchiaretta

    1 reply

    gschmitt
    gschmitt
    New Member
    July 8, 2015

    This shouldn't be the issue but just to make sure...

     

    at System > Network > Interfaces what is the Administrative Status of the port?

    federico123
    federico123Author
    New Member
    July 9, 2015

    Hi gschmitt, Thanks for your reply. Administrative status is set to up. My guess is problem is hardware related, I never had a similar issue with lower end fortigate, and it's the first time I use FG800C. Unfortunately I can't find 800C-specific docs to help me. I'm quite sure it's not an hardware fault since I have the same behaviour on both unit (2 unit in HA).

    Terms & ConditionsAccessibility statement