Skip to main content
frederik
frederik
New Member
May 23, 2015
Solved

Fortigate 60D, tunnel and local bridge SSIDs at once?

  • May 23, 2015
  • 2 replies
  • 4079 views

Hi

 

I own a Fortigate 60D and I think about to add 3 FortiAPs. Since the 60D has only 175 Mbps CAPWAP throughput (roughly 21MB/s) its not an option to tunnel the traffic.

 

Nevertheless I would like to setup a guest network with a tunnel mode to isolate the traffic.

 

So my question: can I have two SSIDs on the same FortiAPs one profile with local bridge and the other one in tunnel mode? Has someone this setup running?

 

Thank you very much.

Best answer by gschmitt

Running no but I don't think there should be a problem

 

Just create two SSIDs, one in local brdige with FortiAP's interface and one in Tunnel to Wireless Controller

Create a AP profile which inherits all SSIDs (or select those 2 SSIDs) and apply the profile to your AP

2 replies

gschmitt
gschmittAnswer
New Member
May 23, 2015

Running no but I don't think there should be a problem

 

Just create two SSIDs, one in local brdige with FortiAP's interface and one in Tunnel to Wireless Controller

Create a AP profile which inherits all SSIDs (or select those 2 SSIDs) and apply the profile to your AP

frederik
frederikAuthor
New Member
May 24, 2015

Thank you! I will try this.

Terms & ConditionsAccessibility statement