Skip to main content
VS_engineer
New Member
Mar 27, 2020 6:58 PM UTC
Question

Fortigate 60D inaccessible via MGMT IP

Hello All,

 

I have a Fortigate 60D that is inaccessible via the Management IP although I can access it on the public IP. I can also access it via SSH. When the problem first presented I was on firmware 5.4.9 but I have since upgraded to 6.0.9 build0335.

 

No configuration changes were made and the 60D was rebooted. I checked the Trusted Hosts and the IP is listed. 

 

Any suggestions on possible next steps?  

7 replies

Toshi_Esumi
SuperUser
SuperUser
Mar 27, 2020 8:28 PM UTC

What interface is the "Management IP" configured on? The original "internal" hardware switch interface? And are you saying you can SSH into the Management IP but can't get into via HTTPS/HTTP GUI? I'm assuming you already checked "Administrative Access" on the interface via GUI, or "allowaccess" in CLI to make sure HTTPS and/or HTTP is allowed. Right?

Translate
VS_engineer
New Member
Mar 27, 2020 9:59 PM UTC

Thank you for your response. You are correct, I am unable to access the 60D via the GUI using HTTPS from the management IP. I can access it with no issue using the public IP. I also checked systems admins and the user is added there with the correct IP address in trusted hosts.  HTTPS is allowed as well. I attached a screenshot of my interfaces for reference. I should be able to access the 60D via the 10.35.136.1 address. 

Translate
Toshi_Esumi
SuperUser
SuperUser
Mar 27, 2020 10:28 PM UTC

Did you created a software-sw management-sw including dmz and internal7?

Fortigate's vlan-subinterfaces are not SVI. If the parent interfac is down, all subinterfaces would be down. Do you have internal7 up and that's where you're coming from?

Depending of which interface you're comring from, as orani said, you need to have a proper policy to get to the VLAN.

My guess is you can't even pint 10.35.136.1.

Translate
orani
New Member
Mar 27, 2020 8:29 PM UTC

Is there any policy accepting traffic from the point you are to the management interface?

Translate
Toshi_Esumi
SuperUser
SuperUser
Mar 27, 2020 8:35 PM UTC

You don't need a policy for admin access. Otherwise, when you default the config you can't access it. Policy is needed only coming in one interface and going out another (or same in some special cases) interface.

Translate
Risk and Resilience in the Age of AI. An OT Thought Leadership Summit for Houston's Critical Infrastructure Leaders. Date: Thursday, December 3, 2026. Time: 8:30 am - 1:30 pm (CT). Location: The Westin Houston, Memorial City | 945 Gessner Road, Houston, TX 77024