FortiGate 100D no packets/application on FortiView

Forum|Forum|4 years ago
September 5, 2022
4 replies
1835 views

Currently we're having a problem on checking/monitoring specific packets from each policies. After checking out the cookbook on Fortinet, I found out that there was a application tab under FortiView. Problem is it shows that there's outgoing packets but when I click to check more details there's nothing displayed at the Application tab.

Has anyone else encountered this problem or any suggestion on how to fix it or an alternative way on checking the packets from each policies.

Thank you in advance.

FortiGate

Best answer by akristof

Hi,

If you want to monitor only one IP address, one client, then create separate firewall policy with that IP address in source address, enable application control and put this policy on top before general firewall policy for other clients.

akristof

Staff

Hello,

Do you have application control enabled on the firewall policy? Try to enable it and check then.

NetAdAllcardAuthor

Visitor III

Hi thanks foy the answer. I just enabled application control. Is it only applicable per policy or can I set a sensor for the ip itself?

akristofAnswer

Staff

Hi,

If you want to monitor only one IP address, one client, then create separate firewall policy with that IP address in source address, enable application control and put this policy on top before general firewall policy for other clients.