Forticlient Endpoint Protected Process Service not started

To address the issue of the FortiClient Endpoint Protected Process service not starting, follow these steps:

1. Check Service Status:

   • Open the Windows Services management console by typing services.msc in the Run dialog (Windows key + R).
   • Locate the "FortiClient Endpoint Protected Process" service.
   • Check if the service is set to "Manual" or "Automatic" and attempt to start it manually.

2. Verify Administrative Privileges:

   • Ensure you are logged in with an account that has administrative privileges, as starting certain services may require elevated permissions.

3. Review System Configuration:

   • Open the System Configuration tool by typing msconfig in the Run dialog.
   • Under the "Services" tab, ensure that the FortiClient services are enabled.

4. Check for Conflicting Software:

   • Verify if any other security or endpoint protection software is installed that might conflict with FortiClient. Temporarily disable or uninstall such software to see if the service starts.

5. Reboot in Diagnostic Mode:

   • In the System Configuration tool, select "Diagnostic Startup" under the General tab and reboot the computer. This mode loads only basic devices and services, which can help identify if a third-party service is causing the issue.

6. Reinstall FortiClient:

   • If the issue persists, consider uninstalling and then reinstalling FortiClient to ensure all components are correctly installed.

If these steps do not resolve the issue, further investigation into system logs or contacting Fortinet support may be necessary.