Skip to main content
koreida
koreida
New Member
December 3, 2021
Question

FortiAuthenticator 300F routing and Ftm polling error

  • December 3, 2021
  • 1 reply
  • 1912 views

I recently installed a 300F fortiAuthenticator.
I am using it for sslvpn 2 factor authentication, but I have a strange symptom.

1. Routing issue

Port1 service ip setting Port4 HA IP Setting The default gateway was set to 0.0.0.0/0 port1, but the routing except for the designated route is left as Port4.

2. FTM polling error: cannot connect to database 30909

I log in with the system account and it doesn't work.
look at the log when it does not work, there is an FTM Error log.

Os version : v6.2.0, build5118 (GA)

1 reply

Markus_M
Staff & Editor
Markus_M
Staff & Editor
December 4, 2021

Hey Koreida,

 

the FTM-polling error is interesting, not sure what to make of it. It might be related to the routing issue.

Do a get system status and see whether there is a HA setting called "node specific gateway". If it is set, you will see that all traffic for this node will leave on that port, not considering static routes. You might not need that setting, though.

 

More troubleshooting tools:

show router static

exec tcpdump -nni port1 and run exec ping 8.8.8.8 on another SSH session

diag netlink route

 

Best regards,

 

Markus

 

Best regards,

 

Markus

 

Terms & ConditionsAccessibility statement