Skip to main content
Jedi_Master
New Member
August 13, 2019
Question

FortiAP 224D only getting 20-30mbps

  • August 13, 2019
  • 1 reply
  • 5518 views

Hello, 

 

I am running a FortiGate 60E->FortiSwitch 108D->FortiAP 224D. My current ISP is Spectrum, where I get 200mbps down. 

 

I have tested with being connected directly to the FortiGate and the FortiSwitch, where I am getting between 170 and 190 down, but when I am connected to the FortiAP, I am lucky to get 30. I have tested with only 1 device connected, low CPU and Memory usage on the AP, low channel utilization, and confirmed that there were 0 interfering APs at the time of the test. I checked the datasheet, and it is supposed to go up to 300mbps. 

 

I have disabled all UTM features as part of troubleshooting. I have confirmed low speeds occur on both a bridged and a tunneled SSID. 

    1 reply

    abelio
    SuperUser
    SuperUser
    August 14, 2019

    Hi,

    did you enable DTLS ?

     

    you could check that with, for example:

     

    show full wireless-controller wtp-profile | grep dtls

    Jedi_Master
    New Member
    August 14, 2019

    DTLS is not enabled: 

    show full wireless-controller wtp-profile | grep dtls

    set dtls-policy clear-text

    alex_buric
    New Member
    August 22, 2019

    please share wireless section config