Skip to main content
jpapic
Explorer
Mar 6, 2026 6:57 PM UTC
Question

FEX-Extender default route affecting traffic

Hello all,


I'm currently working with a FortiExtender (FEX-Extender) and noticed that by default it creates a static route:

0.0.0.0/0 with distance 1 and priority 1.


This route is affecting my traffic because it becomes the preferred default route. When I try to change the distance to 11 (or modify the priority) and push the configuration via FortiManager, I lose connectivity to the FortiGate and I'm unable to continue working remotely.


I also noticed that on the FEX interface the option "Retrieve default gateway from server" is enabled.

Should this option be disabled in this scenario?


Thanks in advance.

4 replies

yderek
Staff
Staff
Mar 9, 2026 12:33 AM UTC

@jpapic 

Please try to check below KB for your reference 

https://community.fortinet.com/t5/FortiGate/Technical-Tip-Override-default-route-settings-default-route/ta-p/192605

The DHCP obtained interface will have inject the static route which has lower distance and AD which is expected

Do you have any other link or static route which your prefer to override the one from FEX ? 

 

Translate
jpapic
jpapicAuthor
Explorer
Mar 9, 2026 2:11 PM UTC

Hello,

I made the changes in the document, but every time I apply them I get an install error and the changes are not applied.

The main issue is that I need to maintain two static routes (customer requirement). However, the static route automatically created by the FEX interface is causing routing conflicts in my setup.

Because of this route, I'm experiencing routing issues and I cannot keep the configuration I need for the customer.


Is there a recommended way to manage or override the static route created by the FEX interface?

 

Thanks.

Translate
Staff
Mar 11, 2026 11:08 AM UTC

Hello,

 

Have you tried performing the changes on the FortiGate directly and not trying to push the configuration from the FortiManager?
I would test firstly this, and afterwards if it can be changed directly from the FGT, you can check the Installation Preview on the FMG and see what settings its trying to change if it gives any error messages in case you want to investigate why it cannot be performed from the FMG side.

Hope this helps.
Enea

Translate
sw2090
SuperUser
SuperUser
Mar 9, 2026 3:12 PM UTC

Would using sdwan be a solution?

Then SDWAN would take care of your default route accoarding to your sdwan rules.

Works fine here this way. SDWAN uses the DSL Lines as configured in the rules and when no dsl line is available it uses the FEX.

Translate
Risk and Resilience in the Age of AI. An OT Thought Leadership Summit for Houston's Critical Infrastructure Leaders. Date: Thursday, December 3, 2026. Time: 8:30 am - 1:30 pm (CT). Location: The Westin Houston, Memorial City | 945 Gessner Road, Houston, TX 77024