Explicit Proxy Policy with outgoing NAT

Forum|Forum|9 years ago
March 8, 2017
3 replies
16385 views

Hello forum,

is it possible to configure Explicit Proxy Policy and use a different outgoing IP address as one that is configured for WAN Interface? Unfortunately I cannot see any NAT option within Exp Proxy Policy.

For example - WAN Primary IP 1.1.1.1/24, Secondary IP 2.2.2.2/24

Exp. Proxy Policy use the IP 1.1.1.1 as the source IP address. I would like to change it to 2.2.2.3 for instance. It works correctly with regular IPv4 Policy where I am able to use a dynamic IP Pool and control the NATed source IP address of the outgoing traffic to the Internet.

Thank you advance for any hint.

Jozef

5.4

cmoroAuthor

New Member

To answer to my question, it is possible to configure outgoing IP (WAN Secondary IP in my case) for Explicit Web/FTP Proxy.

# config web-proxy explicit

(explicit) # set outgoing-ip ? Outgoing HTTP requests will leave this IP. An interface must have this IP address.

ravikumarv

New Member

Hi,

I am also facing the same issue. Is there any solution to configure NAT in web proxy policy?

Thanks

Ravi

cmoroAuthor

New Member

Take a look at my last post. You can specify an outgoing IP for Web Explicit Proxy.

AtiT

New Member

Hello,

Is it possible to NAT traffic to another IP address than the interface address?

I need to NAT some subnets and IPs to another IP address than the interface but the communication is broken. I set an IP Pool object under the explicit policy (OS version 5.6.5). I also tried to add the IP Pool address as a secondary address on the outgoing interface but without success.