Hi, To set up email alerts for high bandwidth utilization on each WAN interface when usage exceeds a specific limit, I referred to the document. https://community.fortinet.com/t5/FortiGate/Technical-Tip-Automation-stitch-configuration-for-inbound-and/ta-p/211515 However, based on the document, the configuration is subject to the following conditions: It applies only to specific FortiGate models and versions that are FIPS-CC certified.The setup must be performed when the unit is in its factory default state.If FIPS-CC is not enabled, the configuration will not be applicable.Upon verifying our environment, we have confirmed that FIPS-CC is currently not enabled. Before proceeding, we seek clarification on the following: Does Fortigate 300E support FIPS-CC certification and this configuration?What would be the implications of enabling FIPS-CC in our existing setup?What dependencies should be considered, given that the configuration is supported only on specific versions and models?Is there any other way we can achieve this?Appreciate your guidance before moving forward with the implementation. FortiGate

Explorer III

Question

Email Alert for High Bandwidth Utilization

Hi,

To set up email alerts for high bandwidth utilization on each WAN interface when usage exceeds a specific limit, I referred to the document.

However, based on the document, the configuration is subject to the following conditions:

It applies only to specific FortiGate models and versions that are FIPS-CC certified.
The setup must be performed when the unit is in its factory default state.
If FIPS-CC is not enabled, the configuration will not be applicable.

Upon verifying our environment, we have confirmed that FIPS-CC is currently not enabled. Before proceeding, we seek clarification on the following:

Does Fortigate 300E support FIPS-CC certification and this configuration?
What would be the implications of enabling FIPS-CC in our existing setup?
What dependencies should be considered, given that the configuration is supported only on specific versions and models?
Is there any other way we can achieve this?

Appreciate your guidance before moving forward with the implementation.