New Member

Solved

edit Local-in-policy

Forum|Forum|4 years ago
April 12, 2022
6 replies
9716 views

On my FG100G I have created a local-in-policy with the command:

config firewall local-in-policy

edit 1

Then I have entered just 'set' and hit enter to see a list of all commands but it did not show any command list.

I entered 'show' and it shows the uuid.

I configured the local-in-policy and when I enter show it shows the policy settings and the uuid.

Do I have to remove the uuid or is this something I don't have to worry about?

May thanks in advance

FortiGate

Best answer by Toshi_Esumi

Don't touch it and leave them alone.

https://docs.fortinet.com/document/fortigate/6.0.0/handbook/79854/uuid-support

Toshi

Toshi_EsumiAnswer

SuperUser

Don't touch it and leave them alone.

https://docs.fortinet.com/document/fortigate/6.0.0/handbook/79854/uuid-support

Toshi

FoxxAuthor

New Member

Thank you very much. Have a good one :)

Yurisk

SuperUser

Additionally, you cannot really delete this even if you try to:

FGT-7-2-0 (0) # show config firewall local-in-policy     edit 1         set uuid 697eaaae-bb29-51ec-dd0e-e7b552859385     next end  FGT-7-2-0 (0) # unset uuid  UUID attribute cannot be unset directly. Command fail. Return code -37

yurisk.info - all things Fortinet blog, no ads

FoxxAuthor

New Member

Thanks Yuri :)

marypoppins

New Member

Hello,

"Then I have entered just 'set' and hit enter to see a list of all commands but it did not show any command list."

After typing 'set' command, don't you should type a question mark to see available possibilities (and not enter again)

FoxxAuthor

New Member

Also this issue has been resolved and it turned out the FG50E is faulty and has been replaced.

Sign up

Login with SSO

Login to the community

Login with SSO