Skip to main content
Saba1989
Saba1989
New Member
August 11, 2018
Question

default route in wan load balance state

  • August 11, 2018
  • 2 replies
  • 3820 views

hi everybody

i configured a 200D fortigate wan load balance,step by step i followed fortinet document

but i have a serious problem:

i configured 3 ISP links load balance and one Intranet link seprated i wrote default route and policies but 

load balance can't work and say "there is no route" however Intranet work properly  so i believe maybe i make a mistake in load balance configure

i post my configure

what is my mistake?

 

    2 replies

    Dave_Hall
    Dave_Hall
    New Member
    August 11, 2018

    I'm pretty sure you need to define the static routes for all three "WAN" connections if they are all on static IPs. 

     

    Edit: If you have defined static routes for all three WAN connections, check the routing monitor to see if all three default routes are up. 

    sw2090
    SuperUser
    sw2090
    SuperUser
    August 16, 2018

    Hi,

     

    I use WLLB here too on many FortiGates. I just set a default route that goes over the wllb interface (virtual-wan-link) and Clients have Policy that allows them to go to the internet via virtual-wan-link (=WLLB). This works fine so far.

     

    maybe this helps you...

    Terms & ConditionsAccessibility statement