Configure secondary unit in active/passive HA?
I'm a little confused about how this is supposed to work. I've found multiple articles describing how to configure the master unit, most of which (including the docs) tell me to reset the slave unit to factory defaults, but then a couple of the articles make a vague comment about 'then configure the slave unit', or words to that effect. But the pictures shown are in the GUI, which I can't get to if there is no network configured. If I *do* configure a rudimentary network (e.g. setting IP on a LAN interface), I'm not in factory default mode anymore, no? Or does the slave unit show up on the HA screen, and I click on it and set various things?
Thanks!
