Command show system interface in FortiManager

Forum|Forum|3 years ago
February 16, 2023
4 replies
4081 views

Hi FortiManager is installed as vm at vmware. When I enter command "show system interface", the output is like below. We cannot see port 1 - 5 status since it show it too fast. Please see the below. What command can we use to show port 1 - 5 status? or show one page by one page. Thanks

Best answer by srajeswaran

config system global

set console-output more

end

Can you apply this and check

srajeswaranAnswer

Staff

config system global

set console-output more

end

Can you apply this and check

Debbie_FTNT

Staff & Editor

Hey davidy,

You can also have the CLI show interfaces one at a time:
#show system interface port1
#show system interface port2
#show system interface port3
...

Also, you can scroll in VMware console with key shortcuts:
SHIFT+Page Up scrolls up
SHIFT+Page Down scrolls down

This can be a bit cluncky in my experience; you're paging through instead of really scrolling through, but it does let you go back to earlier output.

I hope it helps!

fortinet-davidyAuthor

New Member

Great! it works. Thanks

BTW, do we have some command to save it?

Debbie_FTNT

Staff & Editor

Some command to save the console output?

Not that I'm aware of - if you use putty or a similar program, you can save the output to a file, but I'm not aware of an option in VMware, my apologies.

There might be one I'm unaware of, I'm no VMware expert.

Sign up

Login with SSO

Login to the community

Login with SSO