Skip to main content
je_suis_sidik
je_suis_sidik
New Member
June 24, 2025
Question

Captive Portal does not work correctly with fortiwifi 60D-POE FortiWiFi-60D-POE v6.0.12,build0419,2

  • June 24, 2025
  • 1 reply
  • 736 views

Good evening everyone,

I hope this message finds you well.

I’m currently working with a FortiWiFi-60D-POE, running firmware version v6.0.12, build0419 (GA), which I intend to configure and connect to my internet box.

I created a WiFi SSID interface with the following settings:

  • A DHCP address range

  • Captive portal enabled

  • MAC address authentication enabled

After completing the setup, I tested the captive portal connection. I was able to obtain an IP address, but the captive portal page does not appear.

I’ve tried accessing it over HTTPS using ports 1000 and 10003, but without success.

Additionally, I’ve noticed that this device is running an older firmware version.
Could this issue be related to a bug in this version?

If anyone has experienced this or has a solution, your help would be greatly appreciated.

Thank you in advance!

 

2.png1.png

 

 

1 reply

AEK
SuperUser
AEK
SuperUser
June 25, 2025

Hi Sidik

Please share this:

show user setting

 

AEK
    je_suis_sidik
    je_suis_sidikAuthor
    New Member
    June 25, 2025

    FW60DP4614001993 # show user setting
    config user setting
    set auth-cert "Fortinet_Factory"
    end

    AEK
    SuperUser
    AEK
    SuperUser
    June 25, 2025

    Try this:

    config user setting
      set auth-type https
      set auth-secure-http enable
    end

    Hope it helps.

    AEK
      Terms & ConditionsAccessibility statement