Cant direct traffic over WAN2 using LLB

flonix wrote:

Hello,

 

I have searched the forums but can not find an answer to this!

 

I have a Fortinet 60E and am trying to setup a couple of devices to go out via WAN2. I have enabled WAN LLB and have both WANs in there. I have then created a WAN LLB Rule that everything from one PC should go out via the WAN2 interface but it isnt working.

 

I have attached a screenshot of the WAN LLB config and the Rule is as follows:

Name: Test1

Source: IP of PC

Destination: all

Criteria: 

Members: wan2

 

There is already a default rule which contains the following:

Name: wan-load-balance

Source: All

Destination: All

Criteria: Source IP

Members: All

 

Pulling my hair out here!

 

Thanks,

Daniel

So your two screenshots are identically same?