Blocking IP address / domain ?

This is done via the ' protection profile' feature, under the Firewall Menu. Change your outbound rule to use a protection profile (create one first if required). Create/Modify protection profile to enable the " URL block" under the " web filtering" sub option. Add the domains which you want to block in the WEB FILTER -> URL BLOCK menu. If you add " doubleclick.net" in there it will block the entire doubleclick domain. If you want to allow access to other parts, then add four entries for the ones you mentioned (ie ns1.doubleclick.net ..... etc) They will then be blocked for http. HOWEVER, to block all traffic, you would have to work out all the IP addresses for each of those and add a deny rule to specifically block them. If you do this, make sure the rule is at the top of RULEBASE POLICY.

Thanks. I was hoping there may have been a quicker way than defining every IP address in a policy. Will give it a shot.

There might be, if you do some lookups for the domains, you may be able to get there ip address range, and thus do one rule for there entire IP subnet.

Well, I had to manually enter all 4 of their IP' s. I could not do a subnet mask range because the IPs 3rd Octet was different on all of them. Everytime I tried to do a mask if would say it was an invalid range.

The entire doubleclick.net subnet is 216.73.80.0/255.255.240.0 using this would block the entire doubleclick company, if thats what you want.