Additional 0.0.0.0/0 address on all interfaces?
Hi, when I run show system interface ? I get the following
fg100d-01 # show system interface ? name Name. IF-xxx static 0.0.0.0 0.0.0.0 192.168.xxx.1 255.255.255.0 up disable vlan enable IF-xxx static 0.0.0.0 0.0.0.0 192.168.xxx.1 255.255.255.0 up disable vlan enable IF-xxx static 0.0.0.0 0.0.0.0 192.168.xxx.1 255.255.255.0 up disable vlan enable IF-xxx static 0.0.0.0 0.0.0.0 192.168.xxx.1 255.255.255.0 up disable vlan enable VPN_xxx static 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0 up disable tunnel enable dmz static 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0 up disable physical enable dmz-xxx static 0.0.0.0 0.0.0.0 192.168.xxx.1 255.255.255.0 up disable vlan enable fext-wan1 dhcp 0.0.0.0 0.0.0.0 xxx.xxx.xxx.xxx 255.255.255.255 up disable fext-wan enable ha1 static 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0 up disable physical enable ha2 static 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0 up disable physical enable mgmt static 0.0.0.0 0.0.0.0 192.168.xxx.1 255.255.255.0 up disable physical enable
Notice that every interface has a 0.0.0.0/0 address in addition to their correct address.
When i show the config on one interface the 0.0.0.0/0 address does not show
fg100d-01 # show system interface FL-xxx config system interface edit "FL-xxx" set vdom "root" set dhcp-relay-service enable set ip 192.168.xxx.1 255.255.255.0 set allowaccess fabric set device-identification enable set role lan set snmp-index 33 set dhcp-relay-ip "192.168.xx.xx" set interface "port4" set vlanid xx next end
I also just started using NetXMS for monitoring and that is reporting an invalid netmask of /0 on each interface
Is this normal or not? If not how can I fix it?
Thanks
Leif
