Skip to main content
daffoml
daffoml
New Member
July 22, 2016
Question

50E and using switchports independantly

  • July 22, 2016
  • 1 reply
  • 3377 views

I'm not sure I'm asking it correctly, but what I have is 3 VLANS setup, besides the built in lan interface.

 

What I'd like to do is have is LAN 1 set as as untagged in VLAN 1, LAN 2 untagged in VLAN 2, LAN 3 untagged in VLAN 3, and LAN 4 untagged in VLAN 4, LAN 5 has VLAN1 untagged, and VLANS 2, 3, and 4 tagged.

 

I have the last part working, where VLAN1 is untagged, and the other 3 are tagged.  I have removed ports 2,3, and 4 from the LAN interface, but now I don't how to make them "dumb" layer 2 ports.

I tried going into the CLI and using the following:

 

config sys interface

edit "vlan3"

set interface "lan4"

end

 

The result was:

VLAN IP or physical interface cannot be changed once a VLAN has been created.

 

So, do I need to wipe it, and start over?

 

Thanks!

 

    1 reply

    ede_pfau
    SuperUser
    ede_pfau
    SuperUser
    July 22, 2016

    Yes, VLAN definitions are not editable. Either you have to remove all references to that (virtual) port (e.g. VLAN2), delete and recreate the VLAN, or get a config backup file, edit and restore (with reboot).

    Toshi_Esumi
    SuperUser
    Toshi_Esumi
    SuperUser
    July 22, 2016

    And, I'm hoping someone would scold me "You're wrong!", but I don't think any FG supports "untagged" vlan access port.

    Terms & ConditionsAccessibility statement