Skip to main content
shan
shan
New Member
July 4, 2017
Solved

30E LAN port enable

  • July 4, 2017
  • 3 replies
  • 8324 views

Hi,

I'm new to forti. I got 30E box and i was configuring. Accidentally disabled LAN port. How to enable the same back??. There is a reset button on box, how to use it to revert to factory defaults?

 

Thnx!

    Best answer by Toshi_Esumi

    Easiest way is getting in via console port and "set status up" on the interface you took down.

    If you want to use the reset button the KB for the older firmware is in tanr's comment in below thread. I would expect a 30E behaves the same.

    https://forum.fortinet.com/tm.aspx?m=141982

     

    3 replies

    Toshi_Esumi
    SuperUser
    Toshi_EsumiAnswer
    SuperUser
    July 4, 2017

    Easiest way is getting in via console port and "set status up" on the interface you took down.

    If you want to use the reset button the KB for the older firmware is in tanr's comment in below thread. I would expect a 30E behaves the same.

    https://forum.fortinet.com/tm.aspx?m=141982

     

    Toshi_Esumi
    SuperUser
    Toshi_Esumi
    SuperUser
    July 6, 2017

    FYI: We happened to have an FG30E temporarily today and my coworker tested the reset button. Basically one of the behaviours described on the old KB was exactly how the FG30E behaved except the time window you can push the button after a power-cycle was expanded to 60sec instead of 30sec in the doc. 

    shan
    shanAuthor
    New Member
    July 6, 2017

    toshiesumi , Thanks for reply. Managed to up through CLI. Cheers!

    Terms & ConditionsAccessibility statement