Skip to main content
BepsiSan
BepsiSan
New Member
August 29, 2023
Solved

100E 10GE SFP+ to Unifi USW-PRO-48-POE SFP+

  • August 29, 2023
  • 2 replies
  • 5103 views

Hello most esteemed professionals, I'm new here and to the Fori world in general. Today I have a particular question for you all that has my mind in a loop and hopefully you can assist?

 

We have a Fortigate 100E and a Unifi Pro 48 port POE switch. My objective is to link them at 10GE so I did the research and found the Multi mode modules for both:

 

Forti: FN-TRAN-SFP+SR

Unifi: OM-MM-10G-D

 

I installed them and they work only issue is that they only connect at 1GE and not 10GE. what should I do to get them to run at the appropriate speeds for my goal and what pointers can you give me?

Looking forward to your knowledge.

Best answer by srajeswaran

Yes, that is possible.

2 replies

srajeswaran
Staff
srajeswaran
Staff
August 29, 2023

As per the datasheet FGT100E don't have 10G ports, the supported interfaces are "Multiple GE RJ45, GE SFP Slots" ref: https://www.fortinet.com/content/dam/fortinet/assets/data-sheets/FortiGate_100E_Series.pdf

We can see FGT100F has 2 10G ports - " Multiple GE RJ45, GE SFP and 10 GE SFP+
slots" Ref: https://www.fortinet.com/content/dam/fortinet/assets/data-sheets/fortigate-100f-series.pdf

BepsiSan
BepsiSanAuthor
New Member
August 29, 2023

image_2023-08-29_144914831.png

 

Thank you for your reply Suraj. Do see however that the module is supported at 10GE as per the picture above and the spec sheet for the transceivers. 

I have some other questions if you'd be able to assist and guide me in the right direction. What would be a more cost effective replacement to facilitate my goal? the 100F is far beyond my budget layout.

The other question is (Pardon my lack of experience with Forti products) would it be possible for me to combine multiple interfaces to create a nic team to get the desired result of 10ge? 

srajeswaran
Staff
srajeswaran
Staff
August 30, 2023

The SFP is supported, but it will operate in 1G speed and not in 10G speed as the port onlt supports 1G.

 

You can consider link aggregation of multiple 1G links to get higher bandwidth (up to 8 links).

Ref: https://community.fortinet.com/t5/FortiGate/Technical-Tip-Link-aggregation-limitation-and-maximum-supported/ta-p/189539

BepsiSan
BepsiSanAuthor
New Member
August 30, 2023

Suraj, thank you!

 

Can I use this aggregate group to become my "lan" interface and can I run multiple vlan sub-interfaces on it, each vlan with its own dhcp server?

Terms & ConditionsAccessibility statement