Technical Note: Unable to read SSID or Access Point information from Ruckus SmartZone
Description
When modeling the Ruckus SmartZone, the following is observed:
- Models are not displaying SSID tab
- Not pulling in managed APs
The Access Point import is not working because the SNMP OID strings used to read the AP table information changed with the newer SmartZone firmware version.
For example, the AP names are now found in enterprises.25053.1.3.2.1.1.2.2.1.5
Scope
Solution
When modeling the Ruckus SmartZone, the following is observed:
- Models are not displaying SSID tab
- Not pulling in managed APs
The Access Point import is not working because the SNMP OID strings used to read the AP table information changed with the newer SmartZone firmware version.
For example, the AP names are now found in enterprises.25053.1.3.2.1.1.2.2.1.5
Scope
Version: Appliance version 8
SZ Controller version: 3.6.0.0.510
Solution
Addressed in version 8.2.6.
Note: It is still possible that the API version may need to be specified in later versions of code. Refer to the Ruckus Smart Zone Device Integration reference manual in the Fortinet Document Library.