Technical Tip: SSL VPN users show as 'Two-factor authentication not enabled'

This situation can occur when a user provides SSL VPN credentials (username+password) and tokens as a concatenated.

This is an expected behavior from FortiGate, as FortiGate cannot see the VPN users on SSL VPN as 2FA (Attachment Below).


However, to address this error alert, it is recommended to provide the user credentials (username and password together) and then allow a brief interval (Seconds) as FortiGate prompts for two-factor authentication (2FA).
Once the token is provided or approved, FortiGate will recognize that the user is successfully enabled with the required 2FA:

In addition, upgrading the firmware to v7.2.9 or later will also resolve this error alert now. FortiGate will be able to recognize VPN users as 2FA-enabled, regardless of whether the credentials and token are provided in a concatenated format:

Note: If a non-user local Two-Factor Authentication like FortiAuthenticator or any third-party solution is implemented, the Two-Factor Authentication for that user will show as 'disabled' on the FortiGate under the SSL VPN monitor. This is expected behavior.