Skip to main content
bstefanovski
Staff
Staff
May 23, 2025 7:04 AM UTC

Technical Tip: Port Link showing up without SFP inserted

Description

This article describes how to resolve an issue where ULL (ultra low latency) ports may show a a link up status without an SFP Inserted.

Scope

FortiGate 40xF/60xF/90xG/320xF/370xF.

Solution

On affected models and ports, users might see an interface shows Link Up status even when no SFP module is inserted.

 

Example:

Port status shows as up, regardless of whether an SFP is present.

 

Run this command:

diagnose hardware deviceinfo nic <interface>

 

Review the link status information:

 ==== Current Link Settings =====
auto-nego :Disable
s_status :Up
s_speed :10000
s_duplex :Full

 

This can cause confusion during troubleshooting or network changes, as the interface falsely appears operational.

 

This behavior can appear due to how signal detection thresholds are managed for ULL ports. When the signal threshold is set too low, the hardware may incorrectly detect a link as up. See Technical Tip: FortiGate 40xF/60xF/90xG/320xF/370xF models reporting link lights on disconnected Ultra-low latency ports for a list of affected models and relevant ports.


Resolution:

  1. Upgrade to FortiOS v7.4.8+, v7.6.5+, or v8.0.0+. For FortiGate 400F/401F, upgrade to FortiOS v7.4.12+, v7.6.7+, or v8.0.0+.

  2. Apply the configuration below to unused ULL ports (note this configuration is only available after upgrade, and only for devices with ULL ports):

 config system interface
    edit "<port_name>"
        config phy-setting
            set signal-ok-threshold-value 12 
        end
    next
 end


Signal threshold value 12 is the maximum value. By default, it is 0.


Example configuration:

config system interface
    edit "x7"
        set vdom "root"
        set type physical
        set mediatype sr
            config phy-setting
                set signal-ok-threshold-value 12
            end
        set snmp-index 33
        set forward-error-correction
        set speed 25000full
    next
end 


This setting guarantees the port only reports a link up when the signal strength is genuinely sufficient and a proper SFP is inserted and operational.

 

Note:

If the port needs to be used, it is recommended to unset signal-ok-threshold.

This configuration option is only available for devices with ultra-low-latency (ULL) interfaces.

 

Related article:

Troubleshooting Tip: SFP/SFP+ transceivers port/fiber link is not coming up

Technical Tips: Availability of Ultra Low Latency (ULL) Port on FortiGate hardware models

    Risk and Resilience in the Age of AI. An OT Thought Leadership Summit for Houston's Critical Infrastructure Leaders. Date: Thursday, December 3, 2026. Time: 8:30 am - 1:30 pm (CT). Location: The Westin Houston, Memorial City | 945 Gessner Road, Houston, TX 77024