Technical Tip: IPsec VPN error 'ike Negotiate SA Error: ike ike [1470]'
| Description | This article describes that the error ike Negotiate SA Error: ike ike [1470] occurred due to the phase-2 Perfect Forward Secrecy (PFS) setting being mismatched. In most cases, site-to-site VPN is with FortiGate to a third-party firewall. |
| Scope | FortiGate 7.0.9 and 7.2.3 above. |
| Solution |
diagnose vpn ike log-filter dst-addr4 x.x.x. <----- Where x.x.x.x is a remote peer IP address.
The following are the other options for the IKE filter:
To stop the debugs :
diagnose debug disable
Note: Starting from v7.4.1, the 'diagnose vpn ike log-filter dst-addr4' command has been changed to 'diagnose vpn ike log filter rem-addr4'. To filter multiple IPv4 remote gateway addresses 'diagnose vpn ike log filter mrem-addr4' could be used.
The IKE debug logs will appear as below:
ike 4:test-P1:18317:test-P2:228618: PFS is disabled ike 4:test-P1:18317:test-P2:228618: lifetime=3600 ike 4:test-P1:18317:test-P2:228618: no proposal chosen ike Negotiate SA Error: ike ike [1470]
Solution: Verify PFS in phase-2 configuration from both sides and make sure that the DH group on phase-2 is identical.
It is also possible to use the CLI:
config vpn ipsec phase2-interface (phase2-interface) # edit test (test) # set pfs enable (test) # set dhgrp 14 (test) # end |
